No ice anti-leakage? ! There are ways to solve the problem of the refrigerator

Recently, many friends will restart the refrigerator at home, and netizens reflect the problem of leakage of the refrigerator. Today Xiao Bian came to find out why the refrigerator leaked. In general, during the use of the refrigerator, in addition to a certain amount of frost inside the box, there should be no accumulation of water; the outside of the box and the floor around the box should also be kept relatively clean and dry, and there should be no accumulation of water.

When there is water in the box and on the ground, it not only affects the appearance, the storage and cooling effect of the food, but also makes the electrical insulation damage possible. Excessive water in the tank and on the ground mainly has the following reasons:

1. The water tray has been filled with water, overflowing to the ground, so that there is water on the ground around the box.

2. There is too much water in the evaporator at the bottom of the tank and it flows to the ground.

3, according to the water tray or evaporator does not put the positive position, partial, oblique or not put in place, and make the water out.

4, water tray or evaporator due to poor quality, by the low temperature (refer to the water dish), high temperature (referring to the evaporator) aging cracking or broken water.

5. The drainage pipe is blocked, and the defrosted water cannot be introduced into the water tray and evaporator but flows into it.

6, the box memory into the food with more water content, such as large pieces of meat, fruits, vegetables and other clean water.

Antifreeze and defrosting devices of refrigerators are damaged. During the wet season, hot air condenses into dew on the outside of the door and flows into the ground.

In view of the above situations, users should analyze the reasons and try to eliminate them. The specific methods are as follows:

1. Dispose of the water in the water tray in time.

2. Discard the water in the evaporator in time.

3. Place the water tray and evaporator in a positive position so that the water in the tank can flow into the water tray and evaporator accurately.

4. Repair the broken water tray and evaporator. If it cannot be repaired, replace it with a new one.

5, circulation drainage pipe. If the user cannot handle it himself, he can ask the professional to solve it.

6. Drain the water from the food, store it in the box, or store it in a bag.

Level Measuring Controller

No.: 00111 material: Aluminum specification: 0-5m optional model: uqk-01l the principle of electronic liquid level switch is to detect the liquid level through the electronic probe, and then process the detected signal through the special liquid chip for level detection When the measured liquid reaches the action point, the chip outputs high-level or low-level signal, and then cooperates with the water level controller to control the liquid level No floating ball and reed, no external mechanical action, pollution resistance and durability, not afraid of the influence of floating objects It can be installed at any angle The vertical installation has certain anti - wave function and is suitable for immersion in water for a long time The working voltage is DC 5-24v, which is very safe This method is practical,

Level Measuring Controller,Magnetic Control Liquid Level Switch,Liquid Level Control Switch Module,Liquid Level Control Stainless Float Ball

Taizhou Jiabo Instrument Technology Co., Ltd. , https://www.taizhoujiabo.com